Ramps 1.4 Endstop Switch 3D Printer Component for RepRap
Description:
The red line should be connected to VCC, black should be connected to GND and the green should be connected to SIGNAL. It’s easy to install.
Main Features:
● It uses 22AWG wire, the copper wire inside of it is very thick, it can be resistant to 2A current and 300V voltage.
● The temperature range of insulating layer is wide, up to 80 degrees.
● It’s not easy to pull off.
● Convenient to plug and use.
Suitable for: Mainboard Control
Package size: 6.000 x 4.000 x 1.700 cm / 2.362 x 1.575 x 0.669 inches
Package weight: 0.064 kg
Product size: 4.000 x 2.000 x 0.700 cm / 1.575 x 0.787 x 0.276 inches
Product weight: 0.040 kg
Package Contents: 1 x Ramps 1.4 Endstop Switch, 1 x Cable
Package size: 6.000 x 4.000 x 1.700 cm / 2.362 x 1.575 x 0.669 inches
Package weight: 0.064 kg
Product size: 4.000 x 2.000 x 0.700 cm / 1.575 x 0.787 x 0.276 inches
Product weight: 0.040 kg
Package Contents: 1 x Ramps 1.4 Endstop Switch, 1 x Cable
Why buy from us ?
- Friendly customer service, we reply your email within few hours, up to 24 hours. Your happiness is our business.
- Buy with confidence, your money is protected by PayPal Buyer Protection or Stripe payment, where you can file dispute if you don't receive your item etc
- Refund & exchange accepted, we bear the return shipping cost if it's due to our mistake
- All shipping are track-able, so you know when & where about your item delivery
Reviews
There are no reviews yet.